|
*"Plug-N-Play" Installation
*No Adjustments
Required
*"Delay-Repeat" Circuitry
Your Corvette is low and not always
seen by the driver behind you. The Brake Light Pulser modules can give you an
extra measure of safety! This device is full "Plug-N-Play" harness that simply
plugs into your existing Center High Mount Brake Light. There are no wires to
cut, and no adjustments to make. The module automatically pulses your third brake light
when you apply your brakes. The light will pulsate on and off for about a
second, then stays on steady for as long as you press the brake pedal. The unit
is designed to create a gentle fluttering of light, so your car is more
noticeable, yet it doesn't aggravate the driver behind you. The "Delay-Repeat" circuit means the brake lights have to
be off for at least 15 seconds before the cycle can be restarted. So, if you are
in bumper-to-bumper traffic, the brake light isn't always
pulsing. |
